DC Servo 2v68: nAn0 Und3rP4nTs
The nAn0 Und3rP4nTs DC Servo is a fully isolated medium power motor driver shield for the Arduino Nano supporting motors up to 85v. Isolated meaning you can safely use the...
Supported linear rail can be quite expensive, at over $100 per rail per meter, not including shipping. An alternative support was theorized using 3/8″ threaded rod, drilled, tapped and screwed...
After cutting down the Y axis screw for the CNC gantry router project we had a short piece of 3/4 inch Acme leadscrew remaining that was just long enough to...
Bit by bit, piece by piece we have been slowing collecting the parts for the build. We just picked up a 400lb steel table measuring in at 5×8 feet that...
My WindPOV project was featured on Hackaday: http://hackaday.com/2012/03/02/wind-powered-pov-weather-station/ It displays the temperature and humidity on the wing tip by way of persistence of vision. The idea of using our Contiki...
A friend brought over some plastic to CNC mill about a week ago and we got talking about CNC gantry routers and the currently in development DC Servo Drive. Eventually...
NoMi Design has been hard at work creating a CNC capable DC Servo Motion Controller. Based on an earlier design for the “Topology of Dubai” project, the new drive combines...